Jupitercomplete25.06.08.pdf

JUPITER

Operating, Maintenance

& Spare Parts Book

Quivogne UK Ltd.

Fen Farm,

Washbrook,

Ipswich,

Suffolk.

IP8 3HE

Tel: 01473 730 576

Fax: 01473 730 681

web: www.quivogne.co.uk

e-mail: info@quivogne.co.uk

MACHINE DETAILS

Model

Serial Number

Date Of Manufacture

Tractor Linkage To The Machine

Ensure that the height of the tractor drawbar is approximately the same

height as the drawbar of the machine when the machine is standing on the

ground with the frame and drawbar parallel to the ground.

The height of the drawbar of the machine may be adjusted by using the

holes provided in the frame. This will mean that when in work, the

height of the tractor drawbar is approximately 100mm higher than the

machines drawbar (see figure 8).

Adjustment For Levelling The Frame

The level of the frame of the machine may be adjusted by means of the

spring loaded telescopic screw. The frame should be approximately

parallel to the ground when the machine is in work.

When in work the screw allows balanced compressions of the springs on

each side of the articulating block.

Adjusting The Tines (fig.1)

Adjusting the spring tension:

Hold the thread stem (item number 1) with a spanner

Adjust the spring tension with the flat spanner (that was delivered with

the machine) by turning the nut (item number 2). Then tighten the locking

nut (item number 7)

Adjusting the tine angle:

Tighten the adjusting bolt (item number 4)

Tighten the locking nut (item number 6) after achieving the desired angle.

Unfolding The Machine For Work

The machine should be on hard, flat ground before unfolding.

1. Operate the hydraulic wheel lift cylinders to fully raise the

machine.

2. Turn the front to rear levelling screw to ensure that the machine is

parallel to the ground.

3. Operate the hydraulic folding cylinders to ensure the wings are

fully closed.

4. Remove the safety retaining pins (items number 2, fig 7) and place

them in their holders.

5. Operate the hydraulic safety latches (item number 1, fig7) to the

open position.

6. Operate the hydraulic cylinders to unfold the wings into the

working position.

7. Operate the hydraulic safety latches (item number 1, fig7) to the

fully closed position.

Folding The Machine For Transport:

1. Operate the hydraulic wheel lift cylinders to fully raise the

machine.

2. Turn the front to rear levelling screw to ensure that the machine is

parallel to the ground.

3. Operate the hydraulic safety latches (item number 1, fig7) to the

open position.

4. Operate the hydraulic folding cylinders to fully close the wings.

5. Operate the hydraulic safety latches (item number 1, fig7) to the

fully closed position.

6. Remove the safety retaining pins (items number 2, fig 7) from their

holders and place them in the locking position.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: