Kostka w kostce.pdf

Cube In A Cube

ÐIÓm a carver. IÓve always admired whittled curiosities like balls trapped inside a cage, but never wanted to spend the time to make them. I figured there must

be some way to make a similar object with a drill press. Kids play with it like a toy, but it drives adults nuts. They think itÓs a puzzle. TheyÓre sure thereÓs some

way to get the little cube out of the big cube. You canÓt.Ñ

Step1.

Crosscut a 3x3x14-in. blank into four cubes. Solid wood is best, so it doesnÓt look like you put the little cube in the big cube by gluing parts together. Three-in.

table-leg stock works well, but you can make the cubes from 2-1/2 in. or smaller stock if you want.

Step 2.

Mark centerlines on one face. Mark one corner of every face with a small X. YouÓll be drilling each hole more than one time.The XÓs will help register the cube

in the same orientation on the drill press.

Step 3.

Set your drill press to run at its slowest speed. Arrange the belts so the smallest diameter drive pulley turns the idler pulley. Connect the idler to the largest

diameter spindle pulley.

Step 4.

Set up your drill press with a 2 in. Forstner bit. (Use a smaller bit with a smaller block.) Position a fence and stop block so the bit drills exactly in the cubeÓs

center. Drill one hole about 1/16-in. deep.

Step 5.

Set the bitÓs depth of cut. Draw a line from the point where a diagonal intersects the hole you made. Adjust the drill press so the bit stops about 1/16 in. above

this line. This method works for any size cube and any size hole. (IÓve drawn the inner cube so you can see how this works.)

Step 6.

Drill holes in the end-grain sides first. Then drill the other four faces. Always place the XÓs in the same corner relative to the fence and stop block.

Step 7.

Drilling all six faces produces a cube in a cube. The inner cube is attached to the outer cube by a thin section of wood. The reason for drilling the end-grain

faces first is to avoid breaking these weak attachment points. End-grain drilling requires more downward pressure than face-grain drilling.

Step 8.

Set the drill bit 1/32-in. deeper and repeat drilling all the holes. Again, drill the end-grain faces first. Use light pressure to avoid breaking the attachment points.

Step 9.

As you drill, check the thickness of the attachment points. Your goal is to make them as small as possible, to the point where the inner cube almost releases

itself. This may require drilling some holes a tiny bit deeper. Draw check marks to show how many times youÓve drilled each hole.

Step 10.

Release the inner cube by cutting the attachment points with a thin knife, going with the grain. After cutting all eight corners, the inner cube will drop free. But

it wonÓt come out!

Step 11.

Sand the corners of the inner cube. Raise the inner cube above the hole by positioning it at a diagonal. Prop up the cube with a wedge or your fingers.

Step 12.

Sand burn marks or rough grain with a fine-grit drum-sanding attachment. Rub the drum with a crepe-rubber belt cleaner now and then to keep the drum

working efficiently.

Step 13.

Smoothing the faces of the inner cube is tough, because theyÓre hard to get to. I usually just leave them alone, but if you must do some clean-up work, use a

file to start, then switch to sandpaper.

Step 14.

Dip the cube in oil to finish it. Rub thoroughly with a rag to remove the excess oil, and youÓre ready to play!

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: