SA9503GBBT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

SAAB

9-5 *

YEAR. 03 ﬁ

PETROL

DIESEL

MAKE

MOD.

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the side member, driver’s side, in the

engine compartment..

CENTRAL UNIT POSITION

Position the modular systems on the rear left mudguard behind the covering, inside the

boot.

POWER SUPPLY

+30: Connect to the RED wire, at the position B4, in the black connector in the central

located behind the covering in the left side of the boot.

-31: Connect to the BLACK wire, at the position B1, in the BLUE connector in the

central located behind the covering in the left side of the boot.

IGNITION WIRE

+15/54: Connect to RED/BLUE wire, at the position B6, in the black connector in the

central located behind the covering in the left side of the boot..

DIRECTION INDICATORS

For the connection of the front direction indicators connect to the YELLOW wire at the

position nr.3 and LIGHT BLUE wire at the position nr.2 located in the 50 way connector

placed in the lower part of the fuse box, in the driver’s side engine compartment.

For the connection of the rear direction indicators connect to the BROWN wire at the

position D5 and to the BROWN wire at the position D6, in the blue connector, in the

central located behind the covering of the boot, left side.

Divide the lines with 4 diodes.

ACTIV./DEACTIVATION

Connections antitheft/vehicle

CONTROLS

Position

BLUE connector, pos. A6

BLUE connector, pos. A7

BLUE connector, pos. D5

car body

The blue connector is coming out of the operating central located behind the covering

of the boot, left side. Refer to the ‘A’ diagram of the dedicated installations manual in

the kit of the antitheft.

Vehicle

BROWN

GREY

BROWN

ground

IMMOBILISATION POINT

Fuel pump

Cut the wire coming out of the connector of the inertial switch.

STARTER

+50: Cut the wire located in the wiring harness coming out of the ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the BLACK wire located in the lamp above the rudder bar under the driver’s

side dashboard.

BOOT SWITCH

Connect to the wire located in the wiring harness coming out of the boot lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

sa9503gbbt.doc

Art. 3800

YELLOW/BLACK

GREY/BLACK

VIOLET

ORANGE

VIOLET/WHITE

ORANGE/WHITE

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: