BMSE501GBDT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE

BMW

MOD. SERIE 5* YEAR. 01 ﬁ

PETROL

DIESEL

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the bulkhead

of the left lateral mudguard. Pass the cables through the original hole located on the

bulkhead that divides the engine compartment and the passenger’s compartment

corresponding to the passenger’s side shock absorber.

CENTRAL UNIT POSITION

The modular systems and the modules should be positioned under the dashboard,

driver’s side.

POWER SUPPLY

+ 30: connect to the 5 mm 2 RED wire located in a multiway connector at the entrance of

the fuse box.

- 31: Connect with a cable terminal to one of the original ground terminals located on

the left lateral bulkhead , driver’s side.

IGNITION WIRE

+ 15/54: Connect to the 1 mm 2 GREEN/GREY wire located in the wiring harness

behind the right lateral bulkhead, passenger’s side.

DIRECTION INDICATORS

Connect to the 1,5 mm 2 BLUE/GREEN and BLUE/BROWN wires located in the same

wiring harness mentioned above.

ELECTRIC WINDOWS

Comfort closing

Positive control signal

Connect to the BLUE/RED wire, the same used for the activation of art. 38XX.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antitheft/vehicle

Art.38XX Vehicle Position

GREY/BLACK BLUE black connector

YELLOW/BLACK BLACK black connector

VIOLET/WHITE ground car body

ORANGE BLUE/RED wiring harness inside driver’s side door

VIOLET WHITE/BLACK wiring harness inside driver’s side door

ORANGE/WHITE ground car body

The BLUE and BLACK wires are located in the black connector coming out of the central

locking unit placed behind the glove compartment, passenger’s side.

Refer to the diagram nr. 148.

IMMOBILISATION POINT

Gasoil pump

Cut the GREEN/BROWN wire located in the wiring harness coming out of the fuse

marked nr. 15, in the fuse box, placed under the passenger’s side glove compartment.

STARTER

+50: Cut the 3 mm 2 BLACK/YELLOW wire located in the wiring harness coming out of

the connector of the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support grill, driver’s side.

DOORS SWITCH

Connect to the BROWN/RED, BROWN/WHITE, BROWN/GREY and BROWN/WHITE

wires located in the wiring harness coming out of the connector of the central locking

unit.

BOOT SWITCH

Connect to the 1 mm 2 WHITE/BROWN wire located directly in the wiring harness

coming out of the connector of the boot lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

bmse501gbdt.doc

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FITTING DIAGRAM N° 148

Diagram to connect art. 3800 on

BMW 5 serie

Central locking unit

Art. 3800 black connector

Wiring harness inside

driver’s side door

BLUE BLACK

WHITE/ BLUE/

BLACK RED

YELLOW/BLACK

ORANGE/WHITE

VIOLET/WHITE GREY/BLACK

ORANGE

Diodes 1N4004

VIOLET

open close

+30

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

bmse501gbdt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: