PT CRUISER 2001 petrol YES.pdf

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE CHRYSLER MOD. PT CRUISER* YEAR. 01 ﬁ

PETROL

DIESEL

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the support of the servobrake, in the engine

compartment.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+ 30: Connect to the 3 mm 2 RED wire located in a multiway connector, in the fuse box.

- 31: Connect to one of the ground terminals located behind the lateral panel, driver’s side.

IGNITION WIRE

+ 15/54: Connect to the BLUE/BLACK wire, at the position nr. 22, located in the 26 way black

connector coming out of the central doors locking unit fixed under the upper cover of the

dashboard, near the air spouts above the auto radio.

DIRECTION INDICATORS

Connect to the GREEN/RED wires, at the position nr. 1, of the 26 way black connector coming out

of the central doors locking unit fixed under the upper cover of the dashboard, near the air

spouts above the auto radio.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the LIGHT BLUE wire located at the position nr. 14.

Front window, passenger’s side:

cut the BROWN/LIGHT BLUE wire located at the position nr. 7.

Rear window, driver’s side:

cut the LIGHT BLUE/WHITE wire at the position nr. 8.

Rear window, passenger’s side:

cut the GREY/BLACK wire at the position nr. 1.

These wires are located in the 14 way black connector coming out of the push-button panel of the

electric windows.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antithefts/vehicle

Art. 3800 Vehicle Position

YELLOW/BLACK PINK/BLACK pos. nr. 5

GREY/BLACK ORANGE/BLACK pos. nr. 4

VIOLET GREEN pos. nr. 12

ORANGE GREEN/WHITE pos. nr. 11

VIOLET/WHITE ground car body

ORANGE/WHITE positive supply in the fuse box

Make connections in the 26 way black connector, on the radio central placed in the upper part at

the center of the dashboard.

IMMOBILISATION POINT

Fuel pump

Cut the BLUE/BLACK wire located in the 6 way black connector coming out of the central of the

original locking device placed near the ignition key.

STARTER

+50: Cut the YELLOW wire, at the position nr. 6, in the 10 way black connector located on the

left of the steering column.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the BLUE/ORANGE wire, at the position nr. 7, and to the LIGHT BROWN wire, at the

position nr. 25, in the 26 way black connector coming out of the central doors locking unit fixed

under the upper cover of the dashboard, near the air spouts, above the auto radio. To make this

connection it is necessary to divide the lines by means of two diodes.

BOOT SWITCH

Connect to the LIGHT BROWN/BLACK wire, at the position nr. 14, of the 26 way connector

coming out of the central doors locking unit fixed under the upper cover of the dashboard, near

the air spouts, above the auto radio.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

chptc01gbbt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: