********************************************************************* ScanTool.net OBD-II Software v1.08 for ElmScan Copyright (C) 2004 ScanTool.net, All Rights Reserved ********************************************************************* ====================================== ============= Disclaimer ============= ====================================== This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version. This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details. ====================================== ============ Introduction ============ ====================================== ScanTool.net OBDII Software for ElmScan (Windows version) is free software that allows you to use your computer and an inexpensive hardware interface to read information from your car's computer. Version 1.08 allows you to read trouble codes and see their descriptions, clear the codes and turn off the "Check Engine" light, and display real-time sensor data such as RPM, Engine Load, Vehicle Speed, Coolant Temperature, and Timing Advance. For more information about the ElmScan OBD-II interface, please visit our website located at http://www.ScanTool.net ====================================== ===== Minimum System Requirements ==== ====================================== Windows: - 486DX 25Mhz Processor - 4Mb RAM - Windows 95 or higher - DirectX 7 or newer - 640x480 display - Serial port DOS: - 386SX 10Mhz Processor or higher - 1Mb RAM - DOS v3.0 - 640x480 display - Serial port ====================================== =========== Troubleshooting ========== ====================================== If you are having problems running the software, please visit our Support Page located at http://www.scantool.net/support ====================================== =========== Version History ========== ====================================== v1.08 - Fixed problem with ECUs that pad the response with 0's v1.07 - Added the rest of the sensors defined in SAE J1979 (APR2002) Added the rest of "designed to comply with" to Sensor Data Cleaned up portions of the code Added COM ports 5-8 to Options Updated codes.dat with latest generic P and U codes, and removed B and C codes System information dialog supports a wider range of processors and platforms v1.06 - Fixed some problems with RS232, corrected air flow rate formula (US system), added 16 new sensors, modified the layout of "Sensor Data", misc. bug fixes v1.04 - Updated serial library, some bug fixes and enhancements, support for multiple platforms and compilers v1.03 - fixed incorrect display of some sensors when ELM323 is used (July 9, 2002) v1.02 - Minor bug fixes (June 6, 2002) v1.01 - Minor bug fixes (June 5, 2002) v1.00 - Initial release (June 1, 2002) (C) ScanTool.net, 2004
marcinnika