USER MANUAL
· Connect your Omnia Repair Tool to your computer
· Complete the driver installation for Omnia Repair Tool
[ Drivers are placed in the Driver Folder ]
· Connect phone to JTag point as it is shown in the pictures
PCB Layout for Omnia Repair Tool Connection
IMPORTANT NOTICE :
Please Make sure that the connections are properly connected on right connections otherwise software won’t start !
· Start Omnia Repair Tool
Double click on the OmniaTool.exe
Main Software windows should work properly and if connections made properly software should have started without any error messages such as “ Jtag Connection Error ” etc…
· Booting Mobile Phone
Your omnia might be dead but it still able to boot up so place a fully charged battery and power up the headset .
· Click “Repair My Omnia” Now !
If it does not process after you clicked or the software disappears that means the connections been made has problems please check the connections and start over the process ..
· Make sure it is connected until the process successfully completed
· Completing the process you can disconnect the phone !
· Try to flash your phone again with any flash file you required
· In case there is still problems start over the process until you it is successful
In case of “monohans” problems you have to select all the Boot areas included Area0 till to Area9 otherwise it is not required to write Area0
Now your Omnia is Alive ;)
www.omnia-repair.com
misiekyo