Rover.pdf

APPLICATIONS MANUAL

ROVER SECURITY SYSTEM

CONTENTS

PAGE

APPLICATIONS

1.1

CONNECTOR LOCATIONS

2.1

GENERAL OPERATION

3.1

SPECIAL FUNCTIONS

4.1

APM103

Version 2.0 07/01

APPLICATIONS

VEHICLE

SYSTEM YEAR

CABLE

MINI

5AS

95 ON

ADC100 + ADC120/ADC123

100

5AS

95 ON

ADC100 + ADC120/ADC123

200

5AS

95 ON

ADC100 + ADC120/ADC123

400

5AS

95 ON

ADC100 + ADC120

MG-F

5AS

95 ON

ADC100 + ADC120

5AS

95 ON

ADC100 + ADC120

5AS

95 ON

ADC100 + ADC120

MEMS 1.6

MEMS

95 ON

ADC125

MEMS 1.9

MEMS

95 ON

ADC100 + ADC124 or ADC110

MEMS 2J

MEMS

95 ON

ADC110

NOTE : THE SYSTEMS ABOVE USE THE REMOTE PLIP UNIT AS PICTURED BELOW.

ANY OTHER REMOTE PLIPS ARE NOT PROGRAMMABLE WITH THIS SOFTWARE

PLIP KEY FOR USE WITH 5AS, 10AS AND 27VT SYSTEMS

1.1

CONNECTOR LOCATIONS

100

200, 400, 25 & 45

2.1

CONNECTOR LOCATIONS

MEMS 1.6 Connector (3 Pin white)

5AS Connector (3 Pin Green)

2.2

GENERAL OPERATION

SYSTEM DESCRIPTION (5AS ALARM SYSTEM)

INTRODUCTION

There are a number of different systems fitted across the Rover vehicle range, which vary

slightly. The systems can only be enabled and disabled using the Key Fob (PLIP). If the

car is locked with the mechanical key only, then the alarm is not enabled.

There are three ways the alarm works, one is to enable an ultrasonic alarm, the second

Perimetric protection and the other engine immobilisation. In addition to this it also oper-

ates the central locking.

When the system is armed or disarmed the hazard lights will flash depending on which

operation is performed. If the doors lock but the hazard lights do not flash, then it is possi-

ble that one of the doors, boot or bonnet is partially open.

PLIP KEY

This is a radio transmitter which has two buttons, one to arm the system and one to dis-

arm. When the system is armed the ALARM LED indicator will flash quickly for 10 sec-

onds, and then flash at a slower frequency.

The radio code signal is changed each time the PLIP key is used, and the code is

changed both in the handset and also the ECU on the vehicle. If this sequence is broken,

then the PLIP key can be re-enabled as follows :-

Procedure.

Unlock the drivers door using the key.

2. Ensure all doors, bonnet and boot are shut, and if Central Locking is fitted, make

sure both front doors are unlocked.

Press the PLIP key (Lock button) four times quickly, until the vehicle locks are

enabled.

ENGINE IMMOBILISATION

The engine is set as soon as the Perimetric alarm is enabled, which inhibits the engine

electrical circuits. Immobilisation can only be removed using the PLIP key or using the

emergency access code (EKA).

If the car is not locked using the PLIP key, the immobiliser will be activated 20 seconds

after the ignition is switched off, and the drivers door opened. The engine can be re-

immobilised by pressing the unlock button on the PLIP key.

3.1

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: