pies 03.pdf

(19 KB) Pobierz
93633484 UNPDF
Puppy Pounce
By Perry Bailey c 1997
1
2
Valley fold and
unfolding the
diagonal both ways.
Paper white side up.
Valley fold the sides to
the center.
3
4
Valley fold the top flap
down even with the raw
edges of the previously
folded flaps.
Pull out the two side flaps.
93633484.002.png
5
6
Valley fold the sides from the
top to the center of the model.
Reach under to the
hidden center flap
and pull it out.
7
8
Squash fold the flap down
as if making a preliminary base.
Petal fold the top flap up
as if for the bird base.
9
10
1/2
1/2
1/2
1/2
Mark the spot half way between
the corner of the bird base and
the crease formed in step 2.
Valley fold the top layer only
at the angle bisector, then fold
over the flap as shown to form
an irregular rabbits ear. Note,
the long line on the bottom
layer does not go to the tip.
It is formed by flattening the
paper after the two folds on
the top layer.
93633484.003.png
11
Valley fold the flap back
across it’s self, so that the
angle bisector you folded
in the last step is unfolded
in this step.
12
Swivel fold the flap
under itself so the
raw edge and the crease
meet, on the upper part.
The crease will not meet
the edge all along the lower
part.
14
Repeat steps 10 - 13
on other side.
Fold the flap up in a rabbits
ear fold. Note that when
folded up the paper under the
flap that comes to the surface
will be fully extended.
15
13
Valley fold in
half and turn
90 degrees to
the left.
16
Paper thickens
here
1/2
1/2
17
Crimp fold the front of the model back
so that the bottom of the crimp is even with
where the paper thickens at the top, and so
that it will stick up above the surface at the
top
Now we form the head, all it takes in order
left to right, a crimp, a pleat an outside reverse
fold.
93633484.004.png
19
18
Valley fold the legs forward, as seen in 19
Pull the snout down a little to taste.
This is a cut away view of the inside of
the model, is if the entire front half where
missing. At this point work a colour
change on the front legs by taking the
bottom layer of the front leg and pull
it out.
20
21
Then tuck the layer you pulled out in the
previous step and tuck it into the leg, this
will make the leg the same colour as the
body.
Reverse fold the
tips of the front legs in to themselves.
Then reverse fold the top two layers
of the rear end over towards the front.
22
23
Reverse fold the hind end down.
Reverse fold the tail up.
24
25
Fold the tail down
with a crimp fold, then
tuck the outside flaps in to the model.
Crimp fold the
body to form the rear
end of the dog.
(Here is a hint, do it one side at a time.)
93633484.005.png
25
Mountain fold the excess paper up
inside of the model and your done!
26
To See the puppy pounce, just tap his tail!
93633484.001.png

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin