PinFlower.pdf

Summer Rose

By Helga Dharmpaul

Materials Required:

Tracing paper.

Single pricking tool or needle pressed into a cork.

Clear adhesive tape.

Madeira Glissen Gloss in the following colours:

Sterling 06, Rainbow 611.

Madeira Metallic in the following colours:

Astro 4, Metallic 305.

Card mount - DF03U.

To Make The Card:

Trace the dots onto the tracing paper or make

a photocopy of them. Place the central panel of

the card on an embossing pad or some folded

kitchen roll. Place the traced design onto the face

Actual Size

of the card ensuring that the card is unfolded

and taking care to position it centrally. Hold it in

position with a little masking tape, it is important

that it does not move while you are pricking the

design. Using the needle or pricking tool, pierce

a hole through the pattern and card at each dot.

Using Sterling 06, stitch the flower centre.

Fix the end of the thread to the wrong side of

the card with a small piece of clear tape. Follow

the diagram on the next page to determine which

hole to start with and continue until all the holes

are used. Outline the centre circle with Running

Stitch.

Work each petal in turn using Rainbow 611

thread, once again using the diagram to

determine which holes to use first and adding

the Running Stitch once complete. Just use the

Running Stitch around the outer edges and in

between the petals, not around the centre of

the flower.

Stitch the leaves in 305 using the same method

as on the petals.

Back Stitch the stems using every other hole,

see diagram below.

Using Astro 4, work the border design begin-

ning at hole shown taking the thread back in at

the fifteenth hole. Continue until all the holes

have been used.

This diagram shows how each section of the

design is worked, begin by bringing the needle

up at hole 1 and down at hole 2 and then up at 3

and down at 4, etc., continuing until all the holes

are used. This applies regardless of the shape

being worked.

Actual Size

Finally,

work the word

at the bottom

in Running

Stitch using

Astro 4 thread.

The green card above has been stitched onto

an offcut of card which has then been mounted

into an aperture card without the border design.

The large leaf has also been changed into a bud.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: