Moduł Bluetooth w BMW E39.pdf

Installation Instructions

Page 1 of

June 2003

Phone, Navigation Systems

B84 02 03

Product

Development

SUBJECT

BMW Universal Bluetooth TM Hands-Free-Kit

MODEL

E39 - Sedan as of 3/02

E39 - Sport Wagon as of 9/02

"Never use any electronic device or make any inputs while driving that may distract you from driving

safely.

Pay attention to traffic laws and road conditions\situations. Safe vehicle operation is the driver's

responsibility. Always wear your safety belt."

INSTALLATION TIME

The average installation time for this kit is approximately 1 hour.

These instructions were developed especially for BMW vehicles and are not to be compared to any

existing instructions for vehicles other than BMW. No methods other than those specified in this

document are to be used to install the BMW Universal Bluetooth TM Hands-Free Kit .

Please initial and route to the following for information before filing

X Service Manager

X Warranty

X Service Technicians - Initial Below

X Service Advisor

Parts Mgr.

X Service Advisor

Body Shop

X Shop Foreman

PDI Dept.

FIX IT RIGHT THE FIRST TIME, ON TIME, EVERY TIME

 2003 BMW of North America, LLC

by: KRS

PARTS INFORMATION

Description

Qty

BMW Part Number

ULF Control Module

84 21 6 934 552

Voice Input System Jumper Plug

84 11 0 018 038

ULF Control Module Mounting Bracket

(Sedan with Navigation produced 3/02 – 8/02)

84 13 6 924 547

ULF Control Module Mounting Bracket

(Sedan without Navigation produced 3/02 – 8/02)

84 13 6 924 546

E39 Sedan/Sport Wagon Installation Kit

84 11 0 302 647

Installation Kit Contents:

M5 Bolt w/Washer

07 11 9 902 932

M5 Clip Nut

61 13 1 372 033

Wire tie

61 13 1 367 599

Double sided tape with adhesion promoter

Supplied

Eject Box with Tray

84 21 6 933 415

Microphone

84 31 8 380 319

Bluetooth TM Antenna

84 50 8 928 461

ULF Owner’s Manual

84 11 0 302 638

ULF Passkey Reference Card

84 11 0 302 646

ULF E39 Installation Instructions

84 11 0 302 642

Owner’s Manual For Voice Input System

84 11 0 027 942

PROCEDURE:

To install and connect the universal charger/hands-free electronic control unit

Disconnect Battery prior to starting the installation.

A. Eject box and BluetoothTM Antenna Installation:

1. Remove the oddment tray from the center

console by releasing the securing taps (1) on the

tray by pressing in on the taps (2) located on each

side of the armrest and pull the tray up.

2. To remove the armrest, first remove the oddment

tray (2) from the rear of the console using a plastic

pry tool (1) to release the taps on the tray, then

pull the tray out.

3. Slide the ventilation grill (1) down

4. Remove the two screws (2) that hold the armrest

assembly in place.

5. Lift the armrest assembly (1) off of the center

console.

6. Apply an adhesion promoter (1) to the

Bluetooth TM Antenna (2), P/N 84 50 8 928 461

7. Apply the adhesion promoter (1) to an area in the

center console (2).

8. Remove the protective strip from one side of the

double-sided tape and place the double-sided

tape (1) onto the base of the antenna.

9. Remove the protective strip from the double-

sided tape and install the Bluetooth TM antenna

with the tape (1),P/N 84 50 8 928 461 into the

area below the center armrest.

10. Connect the female FAKRA connector (1) to the

antenna.

11. Insert the eject box (1), P/N 84 21 6 933 415 into

the armrest (2) by feeding the wires/connectors

from the eject box (3) through the opening in the

armrest assembly.

12. Connect the black female FAKRA connector (2) to

the male connector and connect the black 18-pin

ELO connector (1) to the 18-pin ELO connector

X4545.

13. Reinstall the armrest and oddment tray

B. Installation of Microphone:

1. Install microphone (1), P/N 84 31 8 380 319 and

connect the black 3-pin connector to the

microphone.

Note: the black 3-pin connector may be taped to

the wiring harness near the interior light

assembly.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: