VOS8004GBD.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE

VOLVO

MOD.

S 80

YEAR 04 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the wheelhouse, passenger’s side.

CENTRAL UNIT POSITION

The modular systems and the modules should be positioned under the dashboard, driver’s

side.

POWER SUPPLY

+30: connect to the 4 mm 2 RED/WHITE wire located in the wiring harness coming out of the

multiway connector, at the entrance of the fuse box.

- 31: connect to one of the original ground cable located behind the left lateral bulkhead,

driver’s side.

IGNITION WIRE

+15/54: connect to the BLUE/RED wire located in the wiring harness coming out of the

central placed under the driver’s side dashboard.

DIRECTION INDICATORS

Connect to the GREEN wire (one of the two), at the position marked ‘SH1’ and to the

GREEN/WHITE wire (one of the two), at the position marked ‘SH2’, behind the central

placed under the driver’s side dashboard.

ELECTRIC WINDOWS

Positive control signal

Front window, drivers side:

cut the RED/BLACK wire on the serial push button, inside the driver’s side door.

Front window, passengers side:

cut the RED/BLACK wire, on the serial push button, inside the driver’s side door.

Rear window, drivers side:

cut the GREEN/BROWN wire, at the position M11 coming out of the windows central unit

located under the dashboard, driver’s side.

Rear window, passengers side:

cut the GREEN/BROWN wire, at the position M12 coming out of the windows central unit

located under the dashboard, driver’s side.

CENTRAL DOORS LOCKING Negative control signal

Connect to the BLUE/WHITE wire (unlock) and to the VIOLET/WHITE wire (lock) in the

wiring harness coming out of the green connector of the push-button panel, directly inside

the driver’s side door.

IMMOBILISATION POINT

Gasoil pump

Cut the GREY wire in the wiring harness coming out of the green connector coming out of

the original locking device central located on the left of the ignition key.

STARTER

+50: cut the YELLOW/WHITE wire located in the wiring harness coming out of the ignition

key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the WHITE wire located in the wiring harness coming out of the lamp placed

under the driver’s side dashboard.

BOOT SWITCH

Connect to the WHITE wire located in the wiring harness coming out of the lamp placed in

the boot.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

vos8004gbd.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: