VOGOL98GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE VOLKSWAGEN MOD. GOLF 4

YEAR 98 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the modular system and the siren in the engine compartment, on the

bulkhead between the engine compartment and the cabin. Run the cables

through the available rubber plug located under the brake fluid reservoir.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the dashboard on the

driver’s side. Alternatively, behind the left-side bulkhead on the driver’s side.

POWER SUPPLY

+ 30 : connect with an eyelet terminal to the pin marked “+30” of the terminal strip

located on the lower part of the fuse box.

- 31 : connect with an eyelet terminal on the grounding shunt up on the left of the

fuse box.

IGNITION WIRE

Connect to the 2 mm 2 BLACK wire in the central area of the fuse box located on

the left-side bulkhead on the driver’s side.

DIRECTION INDICATORS

Connect to the 1 mm 2 BLACK/WHITE and BLACK/GREEN wires in the wiring

harness from the connector of the turn indicator switch.

ELECTRIC WINDOWS

For total window roll up time set the alarm unit roll-up pulse to 24s.

CENTRAL DOORS LOCKING Negative control signal

Connect to the 0,75 mm 2 YELLOW/BLUE lock wire and GREEN/RED unlock wire

in the wiring harness that runs from the push-button panel to the switch inside the

driver’s door.

IMMOBILISATION POINT 1

Cut the 1 mm 2 BLUE/YELLOW wire in the wiring harness that comes out of the 6

way light brown connector located on the connector plate under the dashboard on

the driver’s side.

IMMOBILISATION POINT 2

Cut the 1 mm 2 RED/VIOLET wire that comes off the fuse marked nr. 32 at the

fuse box above the left lateral bulkhead on the driver’s side.

BONNET SWITCH

Install an additional switch on the headlamp support grill, up on the left of the

headlamp on the driver’s side.

DOORS SWITCH

Connect to the 1 mm 2 GREY/BLUE wire at position nr. 16 at the connector that

comes out of the central lock unit located under the dashboard on the driver’s

side.

BOOT SWITCH

Connect to the 1mm 2 BROWN/BLACK wire in the wiring harness of the driver’s

floor trim.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

vogol98gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: