Bizuteria kurs Jewellery handmade jewelery jevelery kolczyki bransoletki naszyjniki koraliki(CRAFTS)_An_Insider_Look_at_Jewelry_Making_and_Beading_Chapter_1 (3).pdf

ONLY AT

BEADSHOP.COM

Wire-Wrapped Bead Bezel

TOOLS NEEDED

A. Bent-nose chain pliers

B. Needle-nose chain pliers

C. Rosary OR

D. Round-nose pliers

E. Wire cutters

F. Tape measure or ruler

G. Wire straighteners

ONLY AT

4' Sterling silver wire, 28-gauge (extra in case you need some for practice) and

2' Sterling silver wire, 24-gauge

1 — 10mm pearl or other smooth, round bead

Making the Wire-Wrapped Bead Bezel

Step 1

Cut 12'' of 24-gauge

wire. Hold the wire with

your pliers and run the

wire straightener jaws

along the wire in the

direction away from

you, removing any

kinks. This is the base

wire that you will

coil around.

Step 2

Cut 20'' of 28-gauge

wire. This is the wire

that you are going to

coil with around the

base wire. Use the wire

straighteners, if

necessary, to smooth

out this wire also.

Step 3

Hold both wires in one

hand and smooth

them together. To begin

coiling the 28-gauge

around the 24-gauge

base wire, find the

spot 4'' from one end.

Start coiling the fine

gauge wire around the

24-gauge wire.

Step 4

Make neat, even coils

close to each other.

If necessary, use the

bent chain nose pliers

to bring them

closer together.

Step 5

Continue to wrap until

there is enough coiled

wire to fit around the

diameter of your bead.

Stop and test the

length, as needed.

ONLY AT

BEADSHOP.COM

Clip

Step 6

Cut a piece of 28-gauge

wire 18'' long. Gently

fold it in half and

center around the

middle of the coil. Feed

the ends of this wire

through the hole of

the bead.

Step 7

Bunch all of the wires

together and choose the

longest 28-gauge wire

to do the weave.

Step 8

Start by wrapping all

wires together to form

the bail. Leave some

open space above the

bead before beginning

the wrap.

Step 9

Wrap around the

bunched wires with

the longest wire,

(approx. 1/2-3/4'').

Gently curve the wires

around a round nose

pliers to form

the bail.

Step 10

Curve the wires in

slightly, using your

round-nose pliers.

Leave out one of the

longest wires to weave

with. Below this curve

is where the remaining

wire swill be clipped away.

Step 11

Wrap the wire several

times around all wires

to secure the loop.

Step 12

Weave the end of your

wire in and around the

center wire going in a

figure 8. Alternate on

each side going back

around the center wire.

Make the weave as neat

and as tight as possible.

This will make your

bezel look its best.

Step 13

Continue to fill the space on top of the pearl by

weaving. To finish, wrap the wire along the side

wire at the end and tuck the end of wire along

the coil on the side of the bead to hide it. Cut any

excess wire using wire cutters. With practice, you

can use 26-gauge (replacing 24) and 30-gauge

(replacing 28). We hope you've enjoyed this

project. Happy Beading!

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: