Cabinet_Design_Rev7.PDF
(
15 KB
)
Pobierz
cab-rev7pdf.PDF
LuSiD’s Arcade Flashback
Cabinet Plans
Revision 7
I. Assembly Notes
It’s a lot easier to cut the cut the groove for the T molding before assembling the cabinet.
The 26” edges of the cabinet bottom need T molding, as well as the cabinet sides.
A few edges should be cut at a 45 angle for everything to fit together. These are both
26” edges of the Cabinet Back – Angled section, and one 30” edge of the Control panel
box Back.
All the measurements assume that 5/8” wood is used for the cabinet. If 3/4" wood is
used, the Coin Door should be 26” X 29 ¾”, and the CP Box Sides should be 14 ½” deep.
To change the width of the cabinet to accommodate a wider or narrower monitor or TV,
change all the 26” measurements to the desired width.
II. Assembly Sequence
1. Start by assembling the cabinet bottom.
The kick plates and lower supports create a
support frame for the base of the cabinet.
You’ll end up with something like this:
Bottom View
2. Next turn it over, frame side down, and attach the side panels. With 6 –8 screws
on each side it should hold itself together long enough to attach the top, back and
sides, which should all be recessed about ½” from the edge of the side panels.
3. Assemble the control panel box seperately, and then attach
it to the cabinet. The bottom of the CP box fits inside the
square created by the 4 sides. The Control Panel top is
held on with velcro.
Side view of CP -Box. Front, back &
bottom
4. Cut the hole for you coin door (if you plan on using one) and attach the T molding
to the cabinet before mounting the door on its hinges. Otherwise the T molding
may affect the alignment of the hinges
LuSiD’s Arcade Flashback, Cabinet Design, rev. 7, page 1
Monitor Shelf
(26” X 22”)
Control
Panel
Cabinet Side 1
LuSiD’s Arcade Flashback , Cabinet Design, rev. 7, page 2
= 1 inch
Control Panel Box -Bottom
(30” X 13”)
Control Panel Box - Back – (30” X 5 ½”)
Control Panel Box – Front - (30” X 3 ½”)
Control
Panel
Cabinet Side 2
LuSiD’s Arcade Flashback , Cabinet Design, rev. 7, page 3
= 1 inch
Cabinet Bottom
( 26” X 38” )
Speaker Panel
(below the marquee)
( 26” X 24”
)
Cabinet Back
Angled section
(26” X 22”)
Cabinet Back
Top section
( 26” X 18” )
Cabinet Front
Coin Door
( 26” X 30” )
CP box – Side 1
Cabinet Back
Bottom section
( 26” X 18” )
CP Box – Side 2
----------- 14 ¼ “ -------------
-
LuSiD’s Arcade Flashback , Cabinet Design, rev. 7, page 4
= 1 inch
Plik z chomika:
marek33x
Inne pliki z tego folderu:
miniMame-instructions.pdf
(659 KB)
galagads.pdf
(71 KB)
galagads.dwg
(116 KB)
Frostillicus_cab_plansPDF.pdf
(191 KB)
defender.dwg
(34 KB)
Inne foldery tego chomika:
CABINETS MAME
Film o rosyjskich technikach walki nożami
Informik.1986-1989
Komputer.1986-1990
Komputer.1986-1990(1)
Zgłoś jeśli
naruszono regulamin