enterprise_bill.pdf

Dollar Bill Enterpri$e

By Perry Bailey Copy-right 1999

FEDERAL RESERVE NOTE

1. Fold up the bill into eights so that the words

Federal reserve note are visible on one side.

Then unfold till only the two outer 1/8ths are

folded in. Turn over.

FEDERAL RESERVE NOTE

2. Valley fold the bill at the “r” in federal.

Collapse the bill back together

while making the folds shown

on the top layer this should

result in a 90 degree turn, when

collapsed

4. The bill should look like this, now turn the

bill so that the long bottom part faces away

from you and open the center two layers.

5. Now ignore the long piece facing away from

you grasp the outer three layers of the

bill and pull them out so that you can see

4 eights of the bill.

6. Now this is a little more difficult, what you do is

you fold the top part forward toward the long part

of the bill while bringing the bottom of the model

together. Note this will not close the bottom of the

completely, see next diagram.

7. This should resemble at least a little the three dimension

object you now hold, if you ignore every thing but the

very back end of it.

8. Fold the sides out one more eighth on each side while

folding the flap downwards.

9. Easily the most confusing move of

this model is this one what you do

is to slide a little of the paper (1

layer) forward a bit mainly towards

the center of the model. Later this

will be used to create domes at the

front of the nacelles.

10. This is easy just fold under

on both sides.

11. Now you have to fold the paper underneath

or there will be less nacelle and too much

body.

12. Fold up a sixteenth while folding the

sides down to a point.

13. An unlucky step this if you were

lucky on the 1st go then you can

fold down about a sixteenth at the

front of the nacelles while only

folding a part of the paper from

step 9 back in while folding the

sides up to form the nacelles

14. Now you get to see the whole model again for a bit, hurrah! Now if we

are all bone with the back patting and what not pull out the trapped layers

as shown to make it look all nice and tidy!

15. Now here the dollar bill gives us a bit of help by giving

a reference of the folding the white part of the bill over

to keep it all in trim.

16. Well this one is another of the few dead easy bits that make

putting up with the parts you have to fudge up a little easier!

Fold part of the bottom of the nacelle up (mountain fold) behind

this finishes shaping the nacelle and gives us another bit to help

lock the model together.

RAL RESERVE NOTE

17. Fold down and flatten the front of the

model using the S and the E in the

words Federal reserve note as the

reference for this fold.

18. Now this is sort of what you would see if you were to look dead

on from the end or front of the model. Valley fold the entire front

of the model up. The next step doesn’t show the entire model.

19. Try to fold the front back down as if to undo

step 17 so that you get something like 20.

RAL RES

20. Reverse fold the entire front of the model forward.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: