furry_bag_en - torebka opis wykonania_ szalon.pdf

(51 KB) Pobierz
Untitled-3
FURRY BAG
approx. size 18 cm x 20 cm
2
Add seam allowances before
cutting bag panels out from
fabric!
MATERIALS
- 30 cm faux fur
- 30 cm babycord for lining, button loop and
shoulder strap
- 1 button, ø 28 mm
1
2
PATTERN PIECES
faux fur lining fabric
front panel
1
1
back panel
1
1
CUTTING
Trace separate pattern piece for front panel from pattern
for back panel. Cut bag panels as indicated on list of pattern
pieces.
Cut also:
- 4 cm x 140 cm strip for shoulder strap
- 4 cm x 9 cm strip for button loop
1
SEWING
Preparation: Stitch ends of shoulder-strap strip together
to form closed loop. Fold and press shoulder strap in half
and turn seam allowances in (raw edges meet in the middle).
Topstitch folded edges together. Fold and press button-loop
strip in half lengthwise, turn seam allowances in (raw edges
meet in the middle) and topstitch folded edges together.
Fold button-loop strip in half at the middle, open strip out
and fold each half down along center fold to form pointed
end and topstitch triangle as shown in sketch.
CONTROL SQUARE
size 2 x 2 inches
Joining: Lay exterior front panel and front lining right sides
together and stitch their top edges together. Understitch
seam allowances to lining. Flip exterior front panel and front
lining wrong sides together and machine-baste their seam
allowances together. Machine-baste button loop at midpoint
of top edge of exterior back panel, right sides together.
Lay bag front section right sides together onto exterior
back panel, following pattern markings. Lay back lining panel
right side down onto exterior bag panel, with bag front
section in between. Stitch bag panels together all around
and leave small opening at outer edge of flap for turning bag
right side out.
Turn bag right side out and close opening by hand-stitching.
Fold flap over on top of bag front section and place shoulder
strap within fold. Stitch casing for shoulder strap through
all layers.
CONTROL SQUARE
size 5 x 5 cm
Finishing: Sew button in place. Gather top edge of bag
slightly by means of shoulder strap. Comb fur out of seams.
You can check by measuring
the dimensions of this control
square that your patterns have
been printed out at the correct
scale. If the dimensions are not
correct, adjust the paper size
setting on your printer to A4
and print the patterns out
again scaled to the correct
size.
copyright © STUDIO TUUMAT OY PL 46 90401 OULU FINLAND INFO: ottobre@ottobre.fi
170228430.001.png

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin